CAT Articulated Truck 725 Specifications Page 53
- Page / 63
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
154 SEBU8524
Maintenance Section
Torque Converter and Transmission Oil - Change
g01126900
Illustration 213
2. Clean the area around filler cap (1) and filler tube
(2). Turn the handle on the dipstick in order to
remove the dipstick. Remove the dipstick in order
to allow the oil to drain.
Note: Before you change the oil, block the front
frame of the machine.
g011
27725
Illustration 214
3. Remove plate (3) in order to access the drain plug
for the torque converter and transmission oil.
Note: Plate (3) is located on the right side of
transmission guard (4) in front of the front axle.
g01127726
Illustration 215
4. Clean the area a
round drain plug (5).
5. Remove the drain plug and the O-ring seal and
retain the dra
in plug and the O-ring seal. Allow the
oil to drain into a suitable container.
6. Inspect the O
-ring seal for the drain plug. If
necessary, replace the O-ring seal. Lubricate the
O-ring seal with transmission oil. Install the O-ring
seal and the
drain plug.
7. Remove the oil filter for the torque converter and
transmissi
on oil. Discard the oil filter. Install a
new oil filter. Refer to Operation and Maintenance
Manual, “Torque Converter and Transmission Oil
Filter - Re
place”.
8. Fill the transmission with new oil through filler
tube (2). F
ill the transmission to the “COLD
SAFE START” range on the oil level dipstick.
Refer to the Operation and Maintenance Manual,
“Capacit
ies (Refill)”, Operation and Maintenance
Manual, “Lubricant Viscosities” and Operation
and Maintenance Manual, “Torque Converter and
Transmis
sion Oil Level - Check”.
9. Guide the dipstick down the filler tube and turn the
handle o
n the dipstick in order to make the seal
between the filler tube and the filler cap.
10. Start th
e engine. Run the engine at low idle.
Inspect the transmission for leaks.
11. Ensure
that the parking brake is engaged.
Engage the service brakes. Slowly operate the
transmission control in order to circulate the oil.
12. Shut off the engine.
13. Repla
ce Plate (3).
14. Wait for five minutes before removing dipstick (1).
Turn
the handle on the dipstick in order to remove
the dipstick.
15. Clea
n the dipstick by wiping.
16. Install the dipstick fully.
17. Check the oil level on the COLD SAFE START
side of the dipstick. The engine can be started
if t
he oil is anywhere within the shaded area. If
necessary, add oil.
18
.
Lo
wer the hood.
19. Start the engine. Operate the machine until the
te
mperature of the oil is at normal operating
temperature.
2
0.
R
aise the hood.
- MAINTENANCE INTERVALS 1
- Operation and 2
- Maintenance 2
- Maintenance Interval Schedule 3
- Autom atic Lubrication Grease 5
- Tank - Fill 5
- (If Equipped) 5
- Grease Recommendations 6
- Backup Alarm - Test 7
- Battery - Recycle 7
- Battery or Battery Cable 7
- Inspect/Replace 7
- Body Pivot Bearings 8
- Brake Pads - Check 9
- Brake System Air - Pu rge 10
- Braking System - Test 11
- Illustration 126 12
- Illustration 127 12
- Illustration 128 12
- Circuit Breakers - R eset 13
- Cooling System Coolant (ELC) 13
- Illustration 131 14
- Illustration 132 14
- Illustration 130 14
- Coo ling System Coo lant 15
- Extender (ELC) - Add 15
- - C heck 15
- Illustration 135 16
- Illustration 137 17
- Illustration 138 17
- Cranksh aft Vibration Dam per 18
- - Change 19
- Level - C h eck 20
- Illustration 146 21
- Inspect/Repl 22
- Engine Air Filter Primary 23
- Element-C 23
- Engine Air Filte r Secon dary 24
- Element - Replac e 24
- Engine Cran kcase Breather 24
- Engine Oil L evel - Ch eck 25
- Engine Oil Sampl e - Obtain 25
- Illustration 156 28
- Illustration 157 28
- Illustration 158 28
- Engine Valve L ash - Check 29
- Ether Starting Aid Cylinder 30
- (OEM Attachmen t if Equipped) 30
- Front Frame 31
- Front Suspension Frame 31
- Oscillating Hitch 31
- Rear Frame 32
- Rear Frames 32
- Dump Body 32
- Radiator Mounts 32
- Mounts for the Suspension 32
- Fuel Sy stem 33
- Fuel System Primary Filter 34
- Illustration 170 35
- Illustration 171 35
- Fuel Syst 36
- Fuel Tank Cap and Strainer 36
- Fuel Tank Water and Sediment 37
- Fuses - Re place 38
- Hoist C ylinder Bearing s 39
- Lubricate 39
- Illustration 178 40
- Illustration 179 40
- Illustration 180 40
- Hydrauli 41
- Hydraulic System Oil Level 42
- Hydrau lic System Oil Samp le 43
- Hydrau lic Tank Breat her 43
- Clean/Inspect/Replace 43
- Hydrau lic Tank Strainer 44
- Clean/Insp ec 44
- Oscillating Hi tch - Ad just 44
- Oscillating Hitch - Lubricate 45
- Radiator Core - Clea n 46
- Refrig erant Dryer - Replace 47
- Rollover Protective Structure 47
- (ROPS) - Inspect 47
- Seat Belt - Insp ect 49
- Seat Belt - Replace 49
- Secondary Steering - Test 49
- Steering Cylinder Bearings 50
- Suspension System - Check 51
- Suspension and Su spen sion 51
- Cylinder Bear 51
- Tire Inflation - Ch eck 52
- Torque Converter and 52
- Transmission O il - Change 52
- Illustration 213 53
- Illustration 214 53
- Illustration 215 53
- Ecology Dr ain 54
- Transmission 55
- Oil Filter 55
- Oil Level 56
- Torque Con 57
- Transmission O il S ample 57
- Illustration 224 58
- Illustration 225 58
- Tran sfer G ear Oil Filter 59
- Illustration 230 60
- Illustration 229 60
- Transfer Gear Oil Samp le 61
- Illustration 232 62
- Illustration 233 62
- Illustration 234 62
- Windows - Clean 63
Related products and manuals for Cars CAT Articulated Truck 725
Cars CAT 735 User Manual
(20 pages)
(20 pages)
Cars CAT Articulated Truck 730 User Manual
(28 pages)
(28 pages)
Cars CAT Articulated Truck 730 User Manual
(16 pages)
(16 pages)
Cars Cat Wheel Loader User Manual
(28 pages)
(28 pages)
Cars Cat Articulated Truck 730 User Manual
(20 pages)
(20 pages)
Cars Cat Articulated Truck 725 User Manual
(20 pages)
(20 pages)
Cars Cat Articulated Truck 740 User Manual
(20 pages)
(20 pages)
Cars Cat 735 User Manual
(20 pages)
(20 pages)
© 2020, manymanuals.com. All rights reserved. | 1.355 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals